High-quality filler & sealant based on acrylic. Can be overpainted. Permanently flexible. Anti crack.

Uses: For filling cracks and gaps around skirting boards, door, architraves, window and door frames, and coving.

Surface Preparations: Application temperature +5°C to +40°C.

All substrates must be clean, dry, and free of grease and dust.

Application instructions: Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed. Smooth down within 20 minutes of application using a welted spatula, piece of wood or wetted gloved finger. Care should be taken at this point not to saturate the surface as this will delay drying.

Cleaning: Tools should be cleaned after use with water. Sealant can be cleaned with water and soap before curing.

Limitations: Not suitable for continues exposure to water. Not suitable for PP, PE, PC, PMMA, PTFE, soft plastics, neoprene and bituminous substrates.

CAUTION:

Keep out of reach of children. Wash skin thoroughly after handling, Wear protective gloves/eye protection/face protection. Dispose of contents/container in accordance with local regulation. Safety data sheet available on request. Bathe the eye with running water for 15 minutes. If irritation persists seek medical attention

Description

High-quality filler & sealant based on acrylic. Can be overpainted. Permanently flexible. Anti crack.

Uses: For filling cracks and gaps around skirting boards, door, architraves, window and door frames, and coving.

Surface Preparations: Application temperature +5°C to +40°C.

All substrates must be clean, dry, and free of grease and dust.

Application instructions: Cut the tip of the cartridge taking care not to damage the thread. Apply nozzle and cut cleanly at an angle of 45° with an opening slightly larger than the gap to be sealed. Apply using a standard sealant gun. Best results will be obtained by keeping an even pressure on the gun trigger and keeping the gun at a constant angle to the surface being sealed. Smooth down within 20 minutes of application using a welted spatula, piece of wood or wetted gloved finger. Care should be taken at this point not to saturate the surface as this will delay drying.

Cleaning: Tools should be cleaned after use with water. Sealant can be cleaned with water and soap before curing.

Limitations: Not suitable for continues exposure to water. Not suitable for PP, PE, PC, PMMA, PTFE, soft plastics, neoprene and bituminous substrates.

CAUTION:

Keep out of reach of children. Wash skin thoroughly after handling, Wear protective gloves/eye protection/face protection. Dispose of contents/container in accordance with local regulation. Safety data sheet available on request. Bathe the eye with running water for 15 minutes. If irritation persists seek medical attention